Here’s how you do it… place your gripper rod on the floor and make a mark with a pencil underneath where the nails are lined up with the floor. After you’ve marked up the space for your carpet gripper, you’ll need to drill a hole and insert a dowel rod. You can then use the dowel rod as a rawl plug for the carpet gripper’s nails. Once you’ve neatly inserted the dowel rod, you just have to hammer the nails in, and you’re done. A perfect installation that will hold your new carpet nicely. How to remove carpet gripper?

The benefits of installing them are to ensure that where the flooring in both rooms meets (the doorway) is held securely. They are essential for safety. Without the bars, the rough edges of the two carpets would be seen and would pose a huge risk of tripping. In time, when continuously walking through the doorway, the carpet will fray and wear down. Not to mention where the carpets meet in the doorway would look unsightly. Use this off-cut from the last sheet in the first row to start the second row and carry on in the same way. This reduces waste and also helps by ensuring the joints are staggered. With the holes drilled, insert the end of your dowel rod into a hole. Make sure it’s a secure fit, because the dowel rod is going to act as a rawlplug, giving the nails of the gripper rod something to sink into. With this easy-to-follow 4-step guide, you should now be ready to fit your door bar over the carpet. Getting the right size is also essential for aesthetics, so carefully measure the width of the doorway. Put your door bar against the frame of the door on the floor and make a mark for the end of your doorway onto the bar.When you’re happy with the position of your marks, use your drill and drill bit to drill into the concrete floor. Use a vacuum cleaner to get rid of any concrete dust. Not only is it unpleasant to breathe in, you’ll want the area clear of debris to ensure a secure installation. If you need to replace your gripper rods with new ones, it can be fiddly, but here’s what you need to do…

You should now have holes filled with dowel rod, ready to accept the fixing nails of your gripper bar. Get your hammer, and hammer those fixing nails into the dowel rods. Whether you fit your carpet yourself or hire a professional, you might find that your carpet sheds some fibres. This is totally normal. Regular vacuuming, daily if possible during the first few weeks, will solve this issue. A vacuum cleaner fitted with a beater bar and/or brushes is recommended for cut pile carpets and one without a beater bar or brushes is best for loop pile carpets. Now, on to actually removing the gripper… Starting at one end of the room, use a chisel to get underneath the gripper and gently hammer along the length of the gripper to loosen it up. You should then be able to lever the nails/adhesive loose and remove them from the floor to make space for new ones.It sounds silly, but ensure the concrete floor you’re going to be drilling into is cleaned and clear of dirt and debris. You’re going to be making marks on the floor, and you don’t want to get your pencil marks confused with existing markings.